Archives

By Christopher Schwarz Page: 29 From the August 2009 issue #177 Buy this issue now Yes, you can mark out your joints with a pocket knife, a craft knife or a sharpened piece of Chevy bumper. But [...]

Delta re-invents its flagship table saw with great success. Bravo. By Glen D. Huey Page: 28 From the August 2009 issue #177 Buy this issue now There’s been so much written about Delta’s new [...]

A great router table for little cost and just a few hours to build. By Robert W. Lang Pages: 74-75 From the June 2009 issue #176 Buy this issue now The original version of this router table was [...]

How do new imported smoothing planes compare to a Lie-Nielsen or Clifton? By Christopher Schwarz Pages: 56-58 From the June 2009 issue #176 Buy this issue now Thanks to the success of Lie-Nielsen [...]

By Christopher Schwarz Page: 29 From the June 2009 issue #176 Buy this issue now My first great set of chisels was made by Ashley Iles, a small manufacturer with deep roots in the toolmaking [...]

By Glen D. Huey Page: 29 From the June 2009 issue #176 Buy this issue now Routers perform a lot of work in the shop, but handheld routers are only part of the story. You can perform even more [...]

This do-it-all band saw has all the power and finesse you’ll need. By Glen D. Huey Page: 28 From the June 2009 issue #176 Buy this issue now Grizzly calls its model G0636X the 17″ Ultimate [...]

By Glen D. Huey Page: 31 From the April 2009 issue #175 Buy this issue now Ridgid now has its version of a granite-top table saw on the market. With the motor mounted inside the cabinet and the [...]

By Glen D. Huey Page: 31 From the April 2009 issue #175 Buy this issue now Many woodworkers rely on random-orbit sanders as their primary method to level an out-of-whack glue-up or for smoothing [...]

New saw design opens the door to hand sawing. By Robert W. Lang Page: 30 From the April 2009 issue #175 Buy this issue now One of the thrills of woodworking is learning a new technique and adding [...]

By Glen D. Huey Page: 40 From the February 2009 issue #174 Buy this issue now Drills have been the focus of many tool manufacturers for a few years now. We’ve had to endure comparisons of [...]

By Christopher Schwarz Page: 38 From the February 2009 issue #174 Buy this issue now For those who think Veritas makes planes that work better than they look, I want you to feast your eyes on the [...]