Archives

For me, the goal with my smoothing plane is to set it up so I can ignore the grain direction of a board or a glued-up panel. There are many valid ways to do this. For most woodworkers I know, …

I’m the weirdo who counts the number of steps and hand motions it takes me to brew a cup of coffee. And I’m always looking for ways to shave away a few minutes here and there from my routine [...]

At long last, there is a fantastic and reasonably priced tri-bolt available so you can make your own campaign stool. The hardware is beautifully machined from solid brass and stainless steel, [...]

Basic handplane theory states that long planes are for straightening wood and short planes are for smoothing it. The planes in the middle can do either job or be set up for roughing out the work. [...]

While walking through the ridiculously tidy racks at Northwest Timber in Jefferson, Ore., I realized at that moment something that hadn’t fully occurred to me during the last 20 years. I am [...]

Some of my favorite tools come from Blue Spruce Toolworks outside Portland, Ore. I own three of the different mallets Dave Jeske makes, plus several of his fantastic chisels and, of course, one [...]

I’ve had a knife in my pocket since I was 11 and couldn’t imagine working in the shop without one. My problem is that the beautiful French knife my wife gave me in 1998 doesn’t have a locking [...]

The only downside to using cut nails is they can split the work, especially when used near the ends of boards. While a properly sized pilot hole will usually prevent splits, there are times when [...]

My favorite project from 2014 is one I haven’t been able to talk much about, until now. Jameel Abraham of Benchcrafted and I collaborated on building a tool chest for a two-article series in [...]

In the early 1990s, Nick Engler and a team of woodworkers and designers took on an incredibly ambitious task: Create a series of how-to books that encompass all of woodworking, from the router to [...]

Woodworking opinion swings with the generations when it comes to picking tools, woods and techniques. Lately I’ve seen a lot of writing about gluing up panels that goes something like this: [...]

A drunken brawl in “Tacuinum Sanitatis.” In our minds, we all have a good idea of what a typical chair, table, stool, desk or workbench looks like and how these pieces are built. But [...]