Tricks of the Trade

In need of some quick lumber storage, I rummaged around my shop for a solution.  I discovered a length of PVC pipe left over from a plumbing job and cut it into three 12″ pieces. I also [...]

Efficient storage is important in my garage shop, so after use, my assembly tables tip, fold, clamp and roll. Each table has one apron-mounted caster ($10 at a home center). I used two sheets of [...]

I made this rack so the finish on my small projects would dry without leaving marks. I cut strips off of a 3/4″ board with my tablesaw’s blade tilted 30 degrees. For each new strip, I just [...]

I use a portable circular saw to break down plywood and other sheet goods into manageable pieces before bringing them to the table saw for final sizing. I prefer to do the job on sawhorses rather [...]

I have a humble number of bar and pipe clamps and no time or desire right now to build a dedicated clamp rack for them. Instead, I installed a standard closet bracket on my shop wall for the [...]

I don’t have a lathe, so when I need to make a cylindrical part, I do it by hand. Using this holding device, I can easily turn a square piece into a round piece using a hand plane—and you can, …

Bessey K-Blocks are great for holding K-clamps in position for glue-ups, but they’re also quite handy for other things. I milled hardwood strips the same dimensions as my K-clamps and use [...]

I found yet another use for my trusty speed squares. Just clamp one or two of them inside the corners of a cabinet when you’re gluing it up. This guarantees that the corners will be square.  [...]

For turning spindles, there’s nothing like having a  really long tool rest. You never have to move it! I made my own with parts from the hardware store. This rest is just a length of square steel [...]

There’s no single surface in my shop that’s the ideal height for every job. With my adjustable-height sawhorses, I can quickly set up an outfeet table, drawing table, or assembly [...]

This jig makes it easy to set up the bit for routing flutes and dadoes. I simply drop the appropriate depth gauge into the channel, set my router on top and lower the bit until it touches the [...]

After building an I Can Do That: Tool Rack , I wanted to have my planes accessible on the rack as well. So here’s my solution. Cut two pieces of oak into 1⁄2” x 3⁄…