Tricks of the Trade

If your shop is inside or attached to your house, you know that migrating sawdust is a problem, especially if you do a lot of power carving.  To minimize dust, I cut out one side of a 65-quart [...]

Here’s a fast, inexpensive way to keep your edge tools razor sharp. First, cut out a few 5″ x 3/4″ MDF discs.  Drill a 1/4″ hole in the center of each disc. Next, glue different [...]

My task: 28 kitchen drawers of different sizes, all with hand-cut dovetails. The thought of laying these out was overwhelming, so I designed a jig to simplify the process. To make the jig, [...]

My dovetail jig doesn’t have a depth gauge, and with my engineering background, I like things to be precise. This depth gauge allows me to set my router bits to within .001 of an inch! I also use [...]

In the good old days, when a woodworker wanted to plane a board’s edge, he’d clamp one end in the bench’s face vise and support the cantilevered end with a free-standing devise called a [...]

Strong and convenient, yellow wood glue is a good choice for most repairs. But there are glues that offer advantages for special situations: SLOWER GLUES: Depending on factors like temperature [...]

When making tenons for breadboard ends and other wide workpieces, the router is my tool of choice. Ensuring perfectly aligned rabbet shoulders on both sides of the board was a problem until I [...]

Any push stick adds a measure of safety, but I prefer using one that straddles the saw’s fence. It lifts right off when I’m done. A saddle-style push stick has two clear advantages. First, [...]

  Tips for taming those awkward and heavy sheets. Woodworking alone is peaceful, serene and quiet. Just you, the radio and your project. It’s also a pain in the posterior when you have to [...]

A complex moulding can be difficult to sand. Softening its crisp edges is a crime, so I’ve been using a thin, flexible stick with sandpaper adhered to it for getting into the flat areas. [...]

When sawdust got packed into the back end of my planer’s blast gate, I couldn’t close the gate all the way.  I solved this annoying problem by cutting a notch in the gate. Now, when I close the [...]

Difficult glue-ups are troublesome enough without having to position clamp pads as part of the process. I’ve tried using hot-melt glue, double-sided tape and various other methods to hold pads [...]