Archives

  Behind the Stairs Storage In my basement shop every square inch counts! Out of necessity I found a wealth of unused space tucked right under my nose, or should I say feet. That awkward [...]

Straight-Shooting Drill Jig You may not face this problem often, but when you need to drill a hole nice and straight but the part is too big to fit on the drill press, here’s what to do: [...]

Double-Decker Mini Clamp Here's a great little clamp for those light-duty hobby or craft jobs. Start with two ordinary clothespins, then modify and combine them as shown above. You now have a [...]

Clean Cuts in a Countertop   Q: I have a plastic laminate countertop that’s about 12 in. too long. I know that plastic laminate tends to chip when cut. How can I trim the countertop to size [...]

Workbench Joint Plans for my knock-down workbench called for the 2 x 4 stretchers to be fastened with bolts and hex nuts. I'd have to rout huge pockets, weakening the stretcher, in order to [...]

Edge-Banding Clamp I ran out of clamps and patience the last time I applied a veneered edge to a long piece of plywood. The tangle of clamps to hold the veneer and cauls in place was more than I [...]

How Can I Avoid Kickback When Resawing on a Tablesaw?   Q: Is there a splitter that can be used for resawing on a tablesaw? Mine is hooked onto the blade guard so it won’t work. A: [...]

Should I Run My Tablesaw on 120 or 240 Volts?   Q: My contractor’s saw pops a breaker every once in a while, and that’s driving me crazy. I noticed that its motor can be wired [...]

Tubular Storage Here’s my solution for storing skinny things like wood trim and edge banding. I bought a 12-in.-dia. by 8-ft.-long cardboard concrete form at a home center for about $14. I [...]

Glue-Up Helper I've always struggled with the rubber bands I use to hold jewelry box sides square and steady during glue-up. The biggest pain in the neck was cleaning the glue squeeze-out [...]

Tabletop Connection Steel tabletop fasteners are a great way to attach a tabletop to its base while still allowing for seasonal changes. On a table with straight aprons, it’s easy enough to [...]

How tight does my blade have to be?   Q: I have a heck of a time loosening the arbor nut when I switch blades on my tablesaw. How hard do I really have to crank on that nut when …