Rare earth magnets set in a steel cup are perfect for all sorts of uses around the shop, but have you ever had to remove one? Once they’re in the cup, the magnets are practically impossible [...]
Monitoring the level of dust in your bin is a pain. You have to remove the lid and look, which isn’t easy. If you forget or put it off, dust will back up into the collector’s main [...]
Featherboards are an important accessory, providing both accuracy and a measure of safety. Typically, a featherboard is just a board with thin fingers sawn into the end that act as springs to [...]
Resin build-up on saw blades makes them less effective. A clean blade runs cooler, doesn’t cause burning on your workpiece, stays sharp longer and cuts more accurately. Cleaning blades is a [...]
Precise height adjustments on router bits and saw blades can be tricky because it’s really hard to see or measure small changes. This 1:8 tapered gauge “magnifies” them. Each [...]
Cutting wooden plugs used to be frustrating. I like to keep the bit going, but each time I would cut a new plug the previous one would be pushed out of the cutter and fly across the shop, landing [...]
A push pad is essential for jointing, routing or ripping because it keeps your fingers away from the danger zone. I’m always on the lookout for a pad that’s larger and grippier than [...]
Clogged sandpaper is really a pain, rendering useless your sandpaper and your effort. I was mindlessly sanding a project a while ago when I looked at my pile of discarded paper and had a [...]
A storage tray is a useful addition to any stationary tool. After adding this one to my tablesaw, I don’t know how I ever did without it. I made the tray about 3″ deep, just deep [...]
Unsatisfactory bandsaw fence? This simple shop-made fence and track system could be the answer. The tracks are formed by gluing up three pieces of hardwood. A slotted fence provides adjustment [...]
The handles on hand-wheels are uncomfortable. The one on my lathe, for example, was difficult to turn when drilling into hard wood with a Forstner bit. Using a chunk of scrap, I turned a 2 [...]
Applying contact cement with a roller is my preferred method, as opposed to spraying it on. There’s not as much clean-up, and I don’t have to deal with overspray. There are drawbacks [...]
