Archives

Get clean cuts and a nice finish from a challenging piece of material. A live edge (or natural-edge) bowl is one of the iconic forms of modern woodturning, and it is still a great way to show off [...]

Hoisting heavy sheets of plywood and MDF onto my tablesaw is not my idea of workshop fun. That’s why I devised this pivoting rack— and began storing my sheet stock vertically. The rack’s frame [...]

Simple to Super Durable Outdoor finishes have one thing in common; they all require maintenance. Of course, paint is unequaled at protecting the wood from its two biggest enemies: moisture and [...]

Hand tools are the way to go for this traditional joint. Tapered sliding dovetails are multipurpose joints traditionally used for drawer dividers, holding legs in place on a pedestal table and [...]

I designed an outfeed support for my table saw that doesn’t take up any floor space. It’s made of plywood, hardwood and a store-bought roller. Three main design features enable it to work well. [...]

Here’s a simple way to protect your chisels from getting nicked and rusty rattling around in your toolbox. Just cut the fingers off some old leather work gloves. Poke holes with an awl at [...]

While making a base for a wooden vase, I had to glue up a small octagonal shape. I made this simple band clamp from a piece of string and a rubber band. Here’s how it works: first, tie one end …

A nice scraper burnisher can be made quickly for little or no cost. All you need is a cheap wooden file handle (available at hardware stores) and an old drill bit. You simply drill into the [...]

I can’t stand throwing away good wood. When I’m turning a goblet or any other object, I don’t leave the waste areas blank. I pick up a gouge or a skew and use the waste to perfect my turning [...]

Ripping very narrow stock on the table saw can be a bit dicey because your push stick runs so close to the blade. If you’re not careful to keep it against the rip fence, it can tip into the [...]

Runaway Router My first router, a 1968 Stanley, was a heavy, single-speed machine. I remember it well because of what happened the very first time I used it. I chucked up a Roman ogee bit and [...]

Every woodworker knows not to rely on inside measurements made with a tape measure. Instead, I use two steel rules with dimensions that run to the edges. I butt one rule at each end, so the [...]