Archives

While making a base for a wooden vase, I had to glue up a small octagonal shape. I made this simple band clamp from a piece of string and a rubber band. Here’s how it works: first, tie one end …

A nice scraper burnisher can be made quickly for little or no cost. All you need is a cheap wooden file handle (available at hardware stores) and an old drill bit. You simply drill into the [...]

Ripping very narrow stock on the table saw can be a bit dicey because your push stick runs so close to the blade. If you’re not careful to keep it against the rip fence, it can tip into the [...]

In my work I often need to draw large-radii curves, for which I use this long beam compass. Built from scrap wood and a dowel center, it’s cheap and easy to make in any length. It can be quickly [...]

Self-centering drill bits (also called “Vix bits”) are great for quick, accurate drilling of hinge screw holes. Unfortunately, they don’t work very well for many continuous, or “piano,” hinges. [...]

When making French cleats using a handplane, getting a consistent beveled edge can be problematic, particularly as the bevel approaches 45º and the plane gets “tippy.” Also, it’s difficult to get [...]

While trying to attach a carved 1⁄8“-thick mahogany veneer to the edge of a curved shelf, an idea came to me as a last moment glue-up solution. Initially I thought I could make it easier to [...]

Like many woodworkers, I use a bench hook to support small pieces on the bench for handsawing. A typical bench hook is just a small panel with a shortened topside fence at one end for supporting [...]

When doing repair work, I often have to inlay small patches of wood into a finished surface. To help level the patch afterward without marring the adjacent surface, I made up several of these [...]

This workshop tip saves both time and money. Make your table saw inserts two-sided to pull double duty on projects.

After cutting out plugs on the drill press, I used to saw them from their blank using the table saw. Unfortunately, this would often send the freed plugs flying across the shop, forcing me to [...]

I use lots of wedges in my shop, sometimes as disposable clamp pads for tricky glue-ups or for general shimming chores. Sometimes they’re incorporated into a project, as when making wedged [...]