Archives

Double-Duty Sanding Drum I sand a lot of thin wood on my drum sander and as a result, I only wear out the bottom part of the drums. Flipping them over allows me to use the top but the middle …

Zero-Clearance Bandsaw Table I like to cut tenons with my bandsaw, but the little cutoffs tend to fall down in the space by the blade and get in the way or bind the blade. I found a slick fix. [...]

Plywood Carrier You don't have to be built like an orangutan to carry plywood! This simple carrier extends your reach and turns an awkward job into an easy one. It's quick to build out of [...]

Thickness Gauge I use this handy device constantly to check and compare thickness on a variety of projects. Slide the gauge over the edge of the stock, keeping the graduated edge flat on the [...]

Router Dado Jig In the course of my work as a contractor, I often need to build cabinets and bookshelves on site – without the luxury of shop tools. I gave up on the flimsy router fence [...]

Machine Floor Locks Anyone with a machine on wheels – especially a tablesaw or planer – understands the necessity of locking it in place before using it. I use a pair of toggle clamps [...]

Smooth-Cutting Hole Saw I cut a lot of discs and large-diameter holes in my shop. I was puzzled for the longest time because I was getting vibration and smoke. It even happened with new hole [...]

Dovetail Marking Jig This little jig greatly speeds the laying out and marking of dovetail pins. Make the jig so the thin piece is exactly the same size as the pin you plan to use. Then, mark a [...]

Easier Resawing I'm stuck with a wimpy 1/2 hp bandsaw that stalled whenever I tried to resaw anything tall. Then my neighbor turned me on to a technique that solved my problem. I pre-cut a [...]

As you can see, I did get into the shop this week to begin on my workbench storage boxes. The thing I most like about building my own design – after 15 plus years building 18th- and early [...]

Bevel Gauge For years I ground a way-too-shallow edge on my favorite chisel. It wouldn't hold up worth beans, so I dug through the junk drawer for something I could make a bevel gauge out of. [...]

This week, I swear I’m getting started on my workbench. To heck with my computer, I need to make dust or something. It’s time to get into the shop. Trouble is, I don’t have, as [...]