Archives

The strong adhesive and tough plastic of packaging tape allow it to work as a hinge on long, mitered corners. After carefully cutting the miters, lay the boards outside-face up and side by side [...]

Simplification and organization are the keys to success. I’ve worked in a small workshop for many years now. Many, if not most woodworkers, would classify my 7′ x 13′ space more as a [...]

My tight finances forced me to devise an alternative to an expensive bench vise. This simple leg vise – cobbled together from a board, a 3⁄4“-diameter pipe clamp, and a short length of [...]

Whenever I have to cut down a sheet of plywood, I reach for one of my trusty metal stud straightedges. Metal studs are available in different thicknesses for different applications. For example, [...]

When crosscutting a series of short pieces from a longer board using the table saw’s miter gauge, it’s dangerous to use the rip fence as a stop. The freed pieces can get jammed between the blade [...]

Here’s a dirt cheap way to store your saw blades and keep their carbide teeth from knocking into each other. Slip the blades onto a 3/8″ dia. landscape nail, using plastic coffee-can lids [...]

I use bench holdfasts because they’re so convenient and provide such a tremendous amount of clamping force. However, in the process, they can mar workpieces, especially softwoods. The traditional [...]

How do you know when your miter gauge is set exactly at 90°? Here’s a method I learned years ago, before I could afford a precision square to check the cut. You’ll need a 24″ [...]

The blade of a marking gauge must be as sharp as a scalpel in order to cut a fine line across the grain. Sharpening it can be very difficult because it’s so small. I solved that problem by [...]

Accurately drilling an angled hole with a hand drill is a challenge – particularly if you’re using a brad point or Forstner bit. This angled drilling guide solves the problem handily. The [...]

When using my miter saw, I’ve found that the easiest way to sneak up on a line is to use a stack of sticky notes. First, set a stop block to cut your part slightly oversize (1/16″ is [...]

After brushing the first coat of finish on my shelf project, quite a bit remained in the disposable cup. I didn’t want to pour it back, because that would contaminate the fresh finish that [...]