Archives

Planing or scraping parts with angled or mitered ends is tricky. Bench dogs will damage a crisp corner, and clamps get in the way. To hold the work, I use an over-sized bench hook with a new [...]

A coping sled is a must-have accessory for router table work. It helps you hold a narrow piece, such as a door rail, perpendicular to the fence and backs up the cut to prevent blowout. At least, [...]

This light-duty clamp is ideal for small parts-and easy to make by the dozen. All you need are a couple wood scraps, a rubber band, and a short piece of dowel rod. You can vary the pressure by [...]

Even with a zero-clearance throat plate in my tablesaw, a thin cut-off slips through now and then. These pieces can clog a vacuum hose or damage the blades of a dust collector.  I made a trap to [...]

Watching an expensive router bit roll onto the floor is a heartbreaking experience. In the middle of a project, it can be a disaster. I drilled a few 1/2” and 1/4” holes in the edge of a piece of [...]

New hardware is often way too shiny for my taste, so I chemically “age” it. If the metal is raw steel, I use standard gun bluing. But if it’s plated with zinc, I turn to Super Blue, a [...]

Chisels don’t wait to get dull until you’ve finished a job—do they? The trick is to keep them sharp while you’re working. Rather than pull out my stones to renew an edge, I keep a piece of MDF [...]

This sandpaper storage system is about as simple as it gets. It’s just a stack of folded envelopes bound with a big rubber band. Each envelope is marked with a grit number. A thin piece of wood [...]

To mark the exact center of a board, I measure an equal distance from both ends and make two marks. This distance is just an approximation—it doesn’t matter if it’s longer or shorter than exactly [...]

Here’s a quick way to glue up a mitered frame of any size using only two clamps, with no worry that the frame will shift out of alignment. You’ll need two 1″ x 1″ hardwood bars (make [...]

Here’s a quick way to get all the dust out of your machine’s nooks and crannies. Most shop vacuums have one port for vacuuming and a second port for blowing. Hook up a hose to each [...]

Drawer Helper Desperation is the mother of invention—isn’t that how the old saying should go for woodworkers? I invented this device when I realized that the drawers in my new armoire tipped down [...]