Archives

While making a base for a wooden vase, I had to glue up a small octagonal shape. I made this simple band clamp from a piece of string and a rubber band. Here’s how it works: first, tie one end …

A nice scraper burnisher can be made quickly for little or no cost. All you need is a cheap wooden file handle (available at hardware stores) and an old drill bit. You simply drill into the [...]

I can’t stand throwing away good wood. When I’m turning a goblet or any other object, I don’t leave the waste areas blank. I pick up a gouge or a skew and use the waste to perfect my turning [...]

Ripping very narrow stock on the table saw can be a bit dicey because your push stick runs so close to the blade. If you’re not careful to keep it against the rip fence, it can tip into the [...]

Every woodworker knows not to rely on inside measurements made with a tape measure. Instead, I use two steel rules with dimensions that run to the edges. I butt one rule at each end, so the [...]

While looking around the shop to find a shim for my dado set, I saw the plastic lid from a cottage cheese container in the trash. Hmm, I thought, that could be it. I trimmed away the edge and [...]

In my work I often need to draw large-radii curves, for which I use this long beam compass. Built from scrap wood and a dowel center, it’s cheap and easy to make in any length. It can be quickly [...]

Like many woodworkers, I use a bench hook to support small pieces on the bench for handsawing. A typical bench hook is just a small panel with a shortened topside fence at one end for supporting [...]

When doing repair work, I often have to inlay small patches of wood into a finished surface. To help level the patch afterward without marring the adjacent surface, I made up several of these [...]

Making an inset drawer line up flush with the face of a cabinet can be fussy work. To make it easy, I just install two screws on the back of the drawer and turn them until the drawer’s front is [...]

Like most planers, mine snipes, overcutting a bit at both ends of a board. Sometimes I’ll simply cut off the sniped areas if I can afford the extra board length. However, with precious woods, [...]

Nothing in handplaning is more frustrating than tear-out