Archives

After cutting out plugs on the drill press, I used to saw them from their blank using the table saw. Unfortunately, this would often send the freed plugs flying across the shop, forcing me to [...]

I use lots of wedges in my shop, sometimes as disposable clamp pads for tricky glue-ups or for general shimming chores. Sometimes they’re incorporated into a project, as when making wedged [...]

When working on small projects, I often need to glue odd-shaped mouldings and tiny trim to box sides and other pieces. Not much pressure is required to hold these small pieces in place, and I [...]

My basement shop is quite small and my drill press is right next to my workbench. When I needed to drill a long board, I would stack pieces of wood on top of my workbench to act as a support.…

Although I have several commercially made accessories for clamping mitered frames, they don’t work well on small frames. So, I devised my own small-frame clamping method. First, I made four [...]

Six great ideas for space-challenged woodworkers to get more out of their small shops.

Like most woodworkers, I never have enough clamps. Adding to a clamp collection is expensive, so when I needed some deep reach clamps, I made these auxiliary hardwood jaws. The jaws are mortised [...]

In need of some quick lumber storage, I rummaged around my shop for a solution.  I discovered a length of PVC pipe left over from a plumbing job and cut it into three 12″ pieces. I also [...]

Efficient storage is important in my garage shop, so after use, my assembly tables tip, fold, clamp and roll. Each table has one apron-mounted caster ($10 at a home center). I used two sheets of [...]

I made this rack so the finish on my small projects would dry without leaving marks. I cut strips off of a 3/4″ board with my tablesaw’s blade tilted 30 degrees. For each new strip, I just [...]

I have a humble number of bar and pipe clamps and no time or desire right now to build a dedicated clamp rack for them. Instead, I installed a standard closet bracket on my shop wall for the [...]

I don’t have a lathe, so when I need to make a cylindrical part, I do it by hand. Using this holding device, I can easily turn a square piece into a round piece using a hand plane—and you can, …