Archives

Specialty hardware can be really annoying. Take the T-bolt—it’s essential for attaching anything to a T-track, but where can you buy one at a moment’s notice? Hardware stores don’t carry T-bolts, [...]

Ordinary push pads tend to slip, I’ve found, when face-jointing a board. I modified one of mine by cutting 1/2″ of the rubber padding off its back end and then screwing on a 1/2″ x [...]

Old bandsaw blades can easily be recycled into useful marking or carving knives. One blade nets you a slew of small pieces. Use a tin snip to cut off a piece of the blade, grind off the teeth, [...]

When finishing a flat panel, I use plastic soda bottle caps as standoffs to raise the panel above the bench. First, I finish the back side of the panel. Then I set the wet side on the upturned [...]

When gluing miters for small mouldings, clear packing tape makes an ideal clamp. Begin by placing a strip of tape across the bottom of the joint; this will prevent glue squeeze-out from getting [...]

While sawing dovetails for a jewelry box, I found my back was hurting from hunching over my bench vise. In order to work more comfortably, I built this vise extension that works on the same [...]

The price of good turning tools can be pretty steep. Since most of the better lathe tools can be purchased without a handle, put your money where it counts—in the steel, not the handle. After [...]

Check out these 11 methods to make layout easier. Write With Chalk Lay out “cut here” marks on rough lumber with chalk. Chalk marks are easy to read, even on the scruffiest surface. Unlike ink, [...]

Some people get pretty worked up about using the right word for the right joint. Perhaps they have a point since imprecise use of terms can lead to confusion. So, to be precise, here are the [...]

I recently thought I’d outfit my portable “benchtop” table saw with a zero-clearance throat plate to reduce tear-out and to prevent narrow strips from falling down through the wide throat [...]

Whenever I need a cup of water or a damp rag, I just turn the spigot on my $3 water jug. That’s much cheaper than plumbing my shop! –O’Neil Long…

My portable planer uses disposable blades. When the first set got dull, I didn’t throw them away–I turned the two blades into very useful drawknives.  I wrapped duct tape around the ends of the [...]