Archives

Tablesaw Storage Cabinet All of your tablesaw accessories close at hand By Eric Smith The last time I could find them all, I counted 18 accessories for my tablesaw. Dado set, push sticks, throat [...]

Glove Finger Chisel Protectors My Chisels used to get dull and rusty rattling around in my toolbox. No more! I found a clever way to protect them. I cut the fingers off some old leather work [...]

Router Base Transfer Points After I lost track of the base plate for the router that goes in my router table, I had to make a new one with accurately marked holes for the mounting screws and a [...]

Vise Crank Handle I'm getting up in years but I still love woodworking. My hands aren't as limber as they used to be, so it was uncomfortable to twist my vise handle. I remembered the [...]

A Brush for Tight Spots Q. I built a little TV stand for our living room that included a 4″ space for the DVD player. It seemed like a great idea until I went to varnish the piece. [...]

Temporary Zero-Clearance Insert My small tablesaw and accessories follow me to jobsites every day. One morning I needed to rip thin slats from a 2 x 4 and wouldn't you know it, I forgot my [...]

Super Chop Saw Stop This stop slides along a rail that's screwed to the top of my chop saw fence, and I can lock it in any position. The hinged block is locked in the down position with a [...]

Groovy Dowels Have you ever tried gluing a pin made from dowel rod in a blind hole? If so you've probably encountered the nasty air pocket that forms at the bottom of the hole and makes [...]

Large Sheet Crosscutting Crosscutting large sheets of plywood on the tablesaw can be difficult, and I usually end up binding the blade, burning the wood, or worse. To get around this, I clamp a [...]

Bench Helper I use this simple device when planing the edges of long boards. It's especially useful when the board is too springy to be clamped between a bench dog and a tail vise. I hold the [...]

Getting the Point I frequently use awls in my work and like to keep them needle-sharp. This little jig takes only a few minutes to make and guarantees a fine, tapered point. Two magnets keep the [...]

Veneer for Edging Instead of buying veneer or edge-banding material for plywood, make your own from scrap left over from the project. This is not only inexpensive, but the edge banding will match [...]